Not a member yet? Why not Sign up today
Create an account  

Thread Rating:
  • 3 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Been gone for a while some questions about the new designer.

#1
So I have been toying around with the new designer, the problems I have run into is you can't make a saucer shaped vessel with the extrusion tool.  If you try and set it to the Z axis it goes completely flat.  

My old race was based around the concept of being... well little grey men.
Reply



Messages In This Thread
Been gone for a while some questions about the new designer. - by Hodo - 07-24-2018, 03:54 AM

Forum Jump:


Users browsing this thread:
2 Guest(s)