Shield Station
|
This section is in need of revision. Please help improve it or discuss these issues on the talk page. The reason given is: Images needed |
| Shield Station |
|---|
| File:Shield Station.png |
| Information |
|
Introduction
The shield station controls the energy shields of the spacecraft. Energy shields absorb some or all of the effects of energy weapons. Energy shields also make the spacecraft hull impervious to transporter beams.
1: Pressing this button will fully recharge the corresponding shield emitter by taking equal energies form all other shield emitter.
2: Pressing this button will transfer a small amount of energies to the corresponding shield emitter by taking equal engine form all other shield emitter.
3: Pressing this button will transfer a small amount of energies of the corresponding shield emitter to all other shield emitter.
4: Pressing this button will transfer all energies of the corresponding shield emitter to all other shield emitter.
5: Representing the strength of the right shield.
6: Representing the strength of the bottom shield.
7: Representing the strength of the rear shield.
8: Pressing this button will activate or deactivate all the shield emitter.
9: Representing the strength of the left shield.
10: Representing the strength of the top shield.
11: Representing your ship.
12: Representing the strength of the corresponding shield emitter, same as ( 5/6/7/9/10/13).
13. Representing the strength of the front shield.
Controls
Controls are activated by clicking on the console using the hand cursor. Controls also have corresponding keyboard equivalents. Help about using the hand cursor and a table showing the key commands for this station can be found on the Keyboard and Mouse Controls page.
A separate energy shield protects each of the six facing directions: front, back, left, right, top and bottom. Each shield facing has its own capacitor, similar to the ship's main capacitor. Energy in a shield's capacitor is used to absorb and dissipate the effects of energy weapons. Each unit of energy in the shield capacitor absorbs 50 units of energy damage, increased by 5% for each tech level above TL1.
Power level of each shield capacitor is shown as a vertical bar graph. There are six bar graphs, one for each shield capacitor. The size of the shield capacitor at each facing is equal to the total number of functioning shield units in the ship design. In a design with 90 shield units, the front shield capacitor holds 90 units of energy, the back shield capacitor holds 90 units of energy, and so on. At TL4, each shield capacitor in that design will absorb 5175 units of energy damage (5175 = 90 * (50 * 1.15)), which is the number reported in the design studio for shield absorption.
The six shield capacitors are interconnected. This enables energy from one shield's capacitor to be instantly transferred to any or all of the other shield capacitors. A shield button at the bottom right corner of the panel causes all available shield energy to be distributed evenly between the six shield capacitors.
Next to each bar graph is a set of four buttons for transferring power between shield capacitors. Maximum shield energy is directed to a facing by using the top control. All shield energy is directed away from a facing by using the bottom control. Shield energy to a facing is increased by pressing the up arrow. Shield energy to a facing is reduced by pressing the down arrow.
Shield energy is distributed to other facings when the energy to a facing is reduced. Likewise, shield energy is taken from other facings when the energy to a facing is increased.
The power to the shield system is turned on and off using the power button at the top left of this station. The shield system must be powered on for shields to absorb damage from energy weapons. The shield system must also be powered on for the shield capacitors to recharge.
Energy is consumed from the ship's main capacitor to recharge the shield capacitors. Shield capacitors recharge at the rate of six energy units per second, distributed between all shield capacitors that need power. If all shield capacitors are empty, each capacitor recharges one energy unit per second. A ship with 90 shield units will take 90 seconds to recharge all shield capacitors from empty. When all shield capacitors are full, no energy is consumed from the ship's main capacitor to maintain the shields until the energy in a shield capacitor is reduced by damage effects. Shield energy is not lost from shield capacitors when the shield system is turned off.