Posts: 5
Threads: 1
Joined: Apr 2020
Reputation:
0
05-12-2020, 10:22 PM
(This post was last modified: 05-12-2020, 10:23 PM by Bludragon.)
Not sure if this is a bug or intended, but:
I had a variety of missiles (no rockets though) in my hold but could not see them in the F5 ordnance tab at the command station
However, when I went to the actual fire control station for the launcher bay, they were there. After that I was able to see the ordnance from the command station
Emperor Bludragon KOUGW
Hope I got everything...
Posts: 5
Threads: 1
Joined: Apr 2020
Reputation:
0
It took me a bit to figure out which station was the launcher window but once I figured it out I still couldn’t see the ordnance, not until i found the actual station (wasn’t easy, i also have 4 harvester bays). I could see the actual launcher dialog window, just with nothing in it.
Posts: 131
Threads: 13
Joined: Jun 2018
Reputation:
7
03-20-2022, 03:22 AM
(This post was last modified: 03-20-2022, 03:42 AM by QuakeIV.)
It appears that the fire control station for that specific weapon system (but not any other fire control consoles) will let you select ordnance, the view above still happened but after a couple of relogs I was able to select ordnance and then proceed to use the weapon system.
Its worth noting another oddity is on the console the weapon system was showing up as 86, but it shows as 85 in the design. The capacitor usage bar was also not displaying correctly, although the capacitor was decremented by the appropriate amount when fired and the weapon appeared to deal full damage.
Posts: 199
Threads: 26
Joined: May 2018
Reputation:
4
03-20-2022, 01:03 PM
(This post was last modified: 03-20-2022, 01:04 PM by Greydog.)
I can load a weapons bay from the captains chair if it is the only fire control station. If there are more than one then the issue reported here becomes apparent.
I plan on living forever ..so far so good!